Infill Angle

< SETTINGS‎ | General‎ | Support Material‎ | Support Options
Revision as of 13:20, 31 December 2018 by Tanderson (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Revision as of 13:20, 31 December 2018 by Tanderson (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Merge

Migrating: For MatterControl 2.0 the MatterControl documentation is moving to matterhackers.com/mattercontrol/support/.
This page is in the process of being migrated. It's new home will be matterhackers.com/mattercontrol/support/slice-settings/support/advanced#infill-angle.

A screenshot of the Infill Angle setting as seen in MatterControl's SETTINGS pane.

Function

The angle at which the support material lines will be drawn.

Parameters

  • degrees

Can be zero.

Example(s)

For this example, Support_test.stl is the model used.

degrees

In this example, the infill angle is 60 degrees as shown on the first layer of the model in 2D Layer View.

Infill Angle-ss-ex.png