Open main menu

First Layer Height

< SETTINGS‎ | General‎ | Layers-Surface‎ | Layer Height
Revision as of 14:43, 17 December 2015 by MatterHackers (Talk | contribs) (Created page with "{{Slice Settings |Sets the height of the first layer. It is often desirable to print a taller first layer to ensure a good solid adhesion to the build plate.|Millimeters or p...")

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Revision as of 14:43, 17 December 2015 by MatterHackers (Talk | contribs) (Created page with "{{Slice Settings |Sets the height of the first layer. It is often desirable to print a taller first layer to ensure a good solid adhesion to the build plate.|Millimeters or p...")

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
A screenshot of the First Layer Height setting as seen in MatterControl's SETTINGS pane.

Function

Sets the height of the first layer. It is often desirable to print a taller first layer to ensure a good solid adhesion to the build plate.

Parameters

Millimeters or percentage

Example(s)

mm

Used as the default if no parameter type is specified. Will create a first layer of the specified millimeters thick.

First Layer Height-ss-ex.png

%

Must enter '%' after input to activate. Used to specify height of first layer relative to Layer Height as a percentage.

First Layer Height-ss-ex1.png

Last modified on 5 September 2018, at 10:07