Infill

< SETTINGS‎ | General‎ | Speed‎ | Speed for Infill

Revision as of 17:13, 18 December 2015 by MatterHackers (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Revision as of 17:13, 18 December 2015 by MatterHackers (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

A screenshot of the Infill setting as seen in MatterControl's SETTINGS pane.

Function

The speed at which infill is printed.

Parameters

Millimeters per second (mm/s)

Example(s)

mm/s

In the case shown below, the infill will print at 40 mm/s.

Last modified on 12 September 2018, at 13:06