Fan Speed

< SETTINGS‎ | General‎ | Raft-Priming‎ | Raft

Revision as of 16:57, 21 December 2015 by MatterHackers (Talk | contribs) (Created page with "{{Slice Settings |The speed at which the cooling fan(s) will run during the printing of the raft, expressed as a percentage.|*percent (%) While the value can be any whole nu...")

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Revision as of 16:57, 21 December 2015 by MatterHackers (Talk | contribs) (Created page with "{{Slice Settings |The speed at which the cooling fan(s) will run during the printing of the raft, expressed as a percentage.|*percent (%) While the value can be any whole nu...")

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

A screenshot of the Fan Speed setting as seen in MatterControl's SETTINGS pane.

Function

The speed at which the cooling fan(s) will run during the printing of the raft, expressed as a percentage.

Parameters

percent (%)

While the value can be any whole number from 0-100, the following values will produce these effects:

0% : off
50% : half speed
100% : full speed

Example(s)

%

At 100% the cooling fan(s) will be on at full blast during the printing of the raft.

Fan Speed-ss-ex.png

Last modified on 6 December 2016, at 17:39