Fan Speed
< SETTINGS | General | Raft-Priming | Raft(Redirected from Settings/General/Raft-Priming/Raft/Fan Speed)
Function
The speed at which the cooling fan(s) will run during the printing of the raft, expressed as a percentage of full power.
Restrictions
- Not shown if Has Fan is disabled.
Parameters
- percent (%)
While the value can be any whole number from 0-100, the following values will produce these effects:
0% : off
50% : half speed
100% : full speed
Example(s)
%
At 100% the cooling fan(s) will be on at full blast during the printing of the raft.
