2,552
edits
Changes
Created page with "{{Slice Settings |G-Code to be run before every tool change (T0, T1, T2, etc.). '''NOTE:''' All Custom G-Code is subject to filtering rules.|*G-Code *..."
{{Slice Settings
|G-Code to be run before every tool change (T0, T1, T2, etc.).
'''NOTE:''' All Custom G-Code is subject to [[G-Code Filtering|filtering rules]].|*G-Code
*[[Custom_G-Code_Variables|Custom G-Code variables]]
All G-Code must be uppercase to function properly.|
=== G-Code ===
In this example, the printer will retract 5 mm of filament before every tool change.}}
|G-Code to be run before every tool change (T0, T1, T2, etc.).
'''NOTE:''' All Custom G-Code is subject to [[G-Code Filtering|filtering rules]].|*G-Code
*[[Custom_G-Code_Variables|Custom G-Code variables]]
All G-Code must be uppercase to function properly.|
=== G-Code ===
In this example, the printer will retract 5 mm of filament before every tool change.}}