Z Offset

< SETTINGS‎ | Printer‎ | Print Leveling‎ | Probe Settings(Redirected from SETTINGS/Printer/Print Leveling/Probe Settings/Manual Probe Paper Width)

A screenshot of the Z Offset setting as seen in MatterControl's SETTINGS pane.

Function

The vertical distance from the Z probe to the nozzle, in millimeters.

For manual probing, this is thickness of the paper (or other calibration device).

Restrictions

Not shown when Has Hardware Leveling is enabled.

Parameters

millimeters (mm)

Example(s)

mm

In this example, the Z probe is 1.6mm higher than the nozzle.

Z Offset1-ss-ex.png

Last modified on 2 August 2017, at 13:53