Changes

Start G-Code

8 bytes added, 19:41, 13 January 2016
no edit summary
== Automatic GCode G-Code Added Before/After Start GCode G-Code ==
MatterSlice adds certain automatically generated code before and after your custom start GCodeG-Code. This normally where your temperature settings would be applied. MatterSlice will wait for the bed to warm up first. Then begin warming the extruder, run your custom start GCodeG-Code, then wait for the extruder to finish heating.
If MatterSlice detects that you have any extruder heating commands (<code>M104</code>, <code>M109</code>) in your custom start GCdeG-Code, it will remove these from the automatic GCodeG-Code. Likewise for bed heating commands (<code>M140</code>, <code>M190</code>).
Here are some examples of the automatic GCodeG-Code:
Before: