Open main menu

Changes

Infill

14 bytes added, 20:49, 11 December 2015
no edit summary
[[File:Infill.jpg|center|frame|A basic cube using [http://wiki.mattercontrol.com/CuraEngine Cura]'s infill pattern at 10%.]]
'''Infill''' is the material used to fill the space between the horizontal layers of a print. It can be assigned a percentage value from 0 to 100%, which changes the density of the material. It is used to increase structural integrity, and can also serve to add weight to a part. Depending on your [[Slice Engines|Slice Engine]], the infill pattern can be changed to suit your needs.
[[Category:Slice Settings]]