User contributions

MatterHackers

10 December 2015

9 December 2015

Template:Slice Settings
no edit summary
18:44
+132
Template:Slice Settings
Created page with "== Function == {{{1}}} == Parameters == {{{2}}} Category:Slice Settings"
18:41
Main Page
no edit summary
18:13
-4
Main Page
no edit summary
18:09
-4
Main Page
no edit summary
18:08
+120
CuraEngine Settings
no edit summary
15:40
+5
CuraEngine Settings
Created page with "__NOTOC__ The slice settings for Cura in MatterControl are divided by three categories: * '''Print''': This is where the settings concerning the actual printed part are loc..."
15:40
Cura Settings
Blanked the page
15:40
-6,890
Category:Features
no edit summary
14:48
+4
Category:Slice Engines
no edit summary
14:46
-23
Main Page
no edit summary
14:36
+7
Frequently Asked Questions
no edit summary
12:56
+34
Main Page
no edit summary
12:55
+234
Category:Troubleshooting
Created page with "MatterControl occasionally has issues, weird behavior, or bugs. Start here to figure out which is which. In addition, we provide support via the following channels: *Find ans..."
12:47
Slic3r Settings
Created page with "__NOTOC__ The slice settings for Slic3r in MatterControl are divided by three categories: * '''Print''': This is where the settings concerning the actual printed part are l..."
12:43
Cura Settings
Created page with "__NOTOC__ The slice settings for Cura in MatterControl are divided by three categories: * '''Print''': This is where the settings concerning the actual printed part are loc..."
12:43
Category:Slice Settings
Created page with "Slice settings are the variables which give the user control over his or her 3D print. Layer height, extruder temperature, and fill density are the most basic of these. Belo..."
12:18
SETTINGS
Redirected page to Category:Slice Settings
12:18
-21,711
Category:Development
Created page with "MatterControl is an open source project written in C#. MatterSlice is also open source and is also written in C#. Both projects are hosted on GitHub: *[https://github.com/Mat..."
12:09
Getting Started
‎Managing Your Print Queue
10:20
-1
Getting Started
‎Show All Settings / User Level (Basic, Intermediate, Advanced)
10:19
-44
Main Page
no edit summary
10:15
-45
MediaWiki:Sidebar
no edit summary
10:13
-9
Getting Started
‎Printing A 3D Object
10:13
Getting Started
‎Setup And Install
10:12
+24

8 December 2015