Search results

Create the page "Slice Settings/Filament/Filament/Filament" on this wiki! See also the search results found.

• SETTINGS/General/Single Print/Settings Will Clear at End of Print/Layer(s) To Pause
  {{Slice Settings ..., at the beginning of which the print will pause, allowing for a change in filament.|*layer number
  525 bytes (85 words) - 11:03, 14 August 2017
• CONTROLS/Tuning Adjustment
  ...speeds as set under the [[Settings/General/Speed|Speed section in General settings]] by multiplying itself times each setting. ...Settings/Filament/Extrusion/Flow/Extrusion Multiplier|Extrusion Multiplier slice setting]] and will work in conjunction with it. For example, if the slicer
  1 KB (193 words) - 11:50, 4 September 2018
• SETTINGS/Filament/Retraction/On Tool Change
  {{Slice Settings Subsection|filament retraction when a tool change occurs.}}
  76 bytes (10 words) - 13:37, 1 December 2016
• SETTINGS/Filament/Material
  {{Migrated|slice-settings/filament/filament}} {{Slice Settings Category|fans and other methods for keeping the print at the right temperat
  281 bytes (31 words) - 19:31, 4 January 2019
• SETTINGS/Filament/Material/Properties/Cost
  {{Migrated|slice-settings/filament/filament#cost}} {{Slice Settings
  388 bytes (63 words) - 15:18, 7 January 2019
• SETTINGS/Filament/Temperatures
  {{Slice Settings Category|temperatures at which the print will run.}} === [[SETTINGS/Filament/Temperatures/Extruder_Temperatures|Extruder Temperatures]] ===
  394 bytes (39 words) - 13:52, 1 December 2016
• SETTINGS/Printer/Print Recovery
  {{Slice Settings Category|MatterControl's Print Recovery feature, allowing the user to resta *This section (Print Recovery) is not shown when [[SETTINGS/Printer/Features/Hardware/Has Hardware Leveling|Has Hardware Leveling]] is
  3 KB (515 words) - 18:21, 9 December 2016
• SETTINGS/Printer/Custom G-Code/Before Tool Change G-Code
  {{Slice Settings In this example, the printer will retract 5 mm of filament before every tool change.}}
  381 bytes (56 words) - 13:37, 1 December 2016
• SETTINGS/Printer/Features/Hardware/Has Filament Runout Sensor
  {{Slice Settings |The printer has a switch for detecting when it has run out of filament. The print is paused if runout is detected.
  600 bytes (97 words) - 17:11, 31 July 2017
• SETTINGS/Filament/Retraction/While Printing/Time For Extra Length
  {{Migrated|slice-settings/filament/retraction#time-for-extra-length}} {{Slice Settings
  655 bytes (103 words) - 11:15, 9 April 2019

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)