Layer(s) To Pause
From MatterControl Manual
< SETTINGS | General | Single Print | Settings Will Clear at End of Print
Revision as of 11:45, 13 September 2016 by MatterHackers (Talk | contribs)
_To_Pause-ss.png)
Function
The layers at which the print will pause, allowing for a change in filament.
Parameters
- layer number
Leave blank to disable. If you would like to pause on multiple layers, separate the layer numbers with semicolons. For example: "15; 37".
Does not work when printing from SD card; the printer must be connected via active serial connection to function properly.
Example(s)
layer number
In this example, the print will pause at the 37th layer to allow the user to change filament.
_To_Pause-ss-ex.png)
