Layer(s) To Pause
From MatterControl Manual
< SETTINGS | General | Single Print | Settings Will Clear at End of Print
Revision as of 12:37, 1 December 2016 by MatterHackers (Talk | contribs) (MatterHackers moved page Settings/General/Single Print/Settings Will Clear at End of Print/Layer(s) To Pause to SETTINGS/General/Single Print/Settings Will Clear at End of Print/Layer(s) To Pause)
_To_Pause-ss.png)
Function
The layers at which the print will pause, allowing for a change in filament.
Parameters
- layer number
Leave blank to disable. If you would like to pause on multiple layers, separate the layer numbers with semicolons. For example: "15; 37".
Does not work when printing from SD card; the printer must be controlling the printer via active serial connection to function properly.
Example(s)
layer number
In this example, the print will pause at the 5th layer to allow the user to change filament.
_To_Pause-ss-ex.png)
