Sailfish Communication
From MatterControl Manual
< SETTINGS | Printer | Features | Hardware
Revision as of 16:01, 31 July 2017 by Tanderson (Talk | contribs) (Created page with "{{Slice Settings |Sets MatterControl to use the S3G communication protocol instead of raw G-Code. This is the method used by Makerbot, Flashforge, and other similar printers....")
Function
Sets MatterControl to use the S3G communication protocol instead of raw G-Code. This is the method used by Makerbot, Flashforge, and other similar printers. You must disconnect and reconnect for this to take effect.
Parameters
- Boolean
Example(s)
Boolean
The check box is checked to use the function.
The check box is unchecked to leave the function unused.
