First Layer Height
From MatterControl Manual
< SETTINGS | General | Layers-Surface | Layer Height
Revision as of 14:43, 17 December 2015 by MatterHackers (Talk | contribs) (Created page with "{{Slice Settings |Sets the height of the first layer. It is often desirable to print a taller first layer to ensure a good solid adhesion to the build plate.|Millimeters or p...")
Function
Sets the height of the first layer. It is often desirable to print a taller first layer to ensure a good solid adhesion to the build plate.
Parameters
Millimeters or percentage
Example(s)
mm
Used as the default if no parameter type is specified. Will create a first layer of the specified millimeters thick.
%
Must enter '%' after input to activate. Used to specify height of first layer relative to Layer Height as a percentage.
