Bottom Clip
From MatterControl Manual
< SETTINGS | General | Single Print | Settings Will Clear at End of Print
Revision as of 17:19, 18 December 2015 by MatterHackers (Talk | contribs)
Function
The amount to remove from the bottom of the model, in millimeters.
Useful for printing portions of a larger print that failed at a certain height so the two pieces can be glued together.
Parameters
- millimeters (mm)
Can be zero.
Example(s)
mm
Specify the amount of the model to remove from slicing, in millimeters. In this example, the bottom 10 mm of the model will not be sliced, and the first layer will start at the layer just above the 10 mm mark.
