Air Gap
From MatterControl Manual
< SETTINGS | General | Raft-Priming | Raft
Revision as of 16:40, 21 December 2015 by MatterHackers (Talk | contribs) (Created page with "{{Slice Settings |The distance between the first layer and the top of the raft. A good value is typically about half the Slice Settings/Printer/Extruder/Extruder X/Nozzle D...")
Function
The distance between the first layer and the top of the raft. A good value is typically about half the extrusion diameter. For a 0.4 mm nozzle, a value between 0.0 and 0.2 would be best.
Parameters
- millimeters (mm)
Example(s)
mm
In this example, a 0.2 mm gap will be left between the raft and the first layer.
