Changes

Jump to: navigation, search

SETTINGS/Printer/Print Recovery/Recover Settings/Recover Layer Speed

50 bytes added, 01:32, 7 December 2016
no edit summary
|The speed at which the nozzle will move when recovering a failed print, for one layer.
Note: Not === Restrictions === *This section (Print Recovery) is not shown when [[SETTINGS/Printer/Features/Hardware/Has Hardware Leveling|Has Hardware Leveling]] is enabled as G29 procedures could interfere with a partially-completed print.|*millimeters per second (mm/s)|
=== mm/s ===
In this example the nozzle will move at 10 mm/s whilst printing the layer the printer was on when it failed.}}
Retrieved from "http://wiki.mattercontrol.com/Special:MobileDiff/3810"

Navigation menu