Changes

CONTROLS/Tuning Adjustment

1,297 bytes added, 00:10, 16 January 2016
no edit summary
{{DISPLAYTITLE:Tuning Adjustment}}
 
__NOTOC__[[File:Tuning Adjustment-ss.png|right|framed|<center>The 'Tuning Adjustment' section of the Controls pane.</center>]]The Tuning Adjustment section of the Controls pane allows the user to change the speed and extrusion values during an active print.
 
Use the slider or enter a value and click '''SET'''.
 
== Speed Multiplier ==
 
When used during an active print, the speed multiplier modifies the speeds as set under the [[Slice Settings/General/Speed|Speed section in General settings]] by multiplying itself times each setting.
 
=== Range ===
 
*Low : 0.5
*High : 2.0
 
== Extrusion Multiplier ==
 
When used during an active print, the extrusion multiplier modifies the extrusion flow rate (as defined in the [[#Formula|formula below]]).
 
This variable is different from that of the [[Slice Settings/Filament/Filament/Filament/Extrusion Multiplier|Extrusion Multiplier slice setting]] and will work in conjunction with it. For example, if the slicer setting is set at 1.06 and then the slider in Controls is used during the print and set to 1.08, the total result will be a multiplier of 1.1448 (1.06 * 1.08).
 
=== Formula ===
 
The general extrusion flow formula: <code>layer height / (filament area (pi*r²) * '''extrusion multiplier''')</code>
 
=== Range ===
 
*Low : 0.5
*High : 3.0
[[Category:Controls]]