Difference between revisions of "CuraEngine"
(Created page with "'''CuraEngine''' is one of the slicing engines that is integrated into MatterControl. The complete list of settings can be found on the Slice Settings page. Category:...") |
|||
| (11 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | '''CuraEngine''' is | + | __NOTOC__'''CuraEngine''' is a third-party slicing engine which has been integrated into MatterControl. |
| − | + | == Origin == | |
| − | [[Category: | + | CuraEngine is written in C++. It was officially released with Cura in June 2013.<ref>[http://reprap.org/wiki/Cura Cura - RepRapWiki]</ref> |
| + | |||
| + | == Documentation == | ||
| + | |||
| + | The complete list of settings can be found on the [[CuraEngine Settings]] page. | ||
| + | |||
| + | == Repository == | ||
| + | |||
| + | CuraEngine is an open source project hosted on GitHub: https://github.com/Ultimaker/CuraEngine | ||
| + | |||
| + | == References == | ||
| + | |||
| + | <references /> | ||
| + | |||
| + | [[Category:Slice Engines]] | ||
Latest revision as of 17:19, 11 February 2016
CuraEngine is a third-party slicing engine which has been integrated into MatterControl.
Origin
CuraEngine is written in C++. It was officially released with Cura in June 2013.[1]
Documentation
The complete list of settings can be found on the CuraEngine Settings page.
Repository
CuraEngine is an open source project hosted on GitHub: https://github.com/Ultimaker/CuraEngine