Difference between revisions of "SETTINGS/Filament/Cooling/Cooling Thresholds/Slow Down If Layer Print Time Is Below"
< SETTINGS | Filament | Cooling | Cooling Thresholds (Created page with "{{Slice Settings |The minimum amount of time a layer must take to print. If a layer will take less than this amount of time, the movement speed is reduced so the layer print...") |
|||
| (3 intermediate revisions by one other user not shown) | |||
| Line 1: | Line 1: | ||
| + | {{Migrated|slice-settings\speed\cooling#slow-down-if-layer-print-time-is-below}} | ||
{{Slice Settings | {{Slice Settings | ||
| − | |The minimum amount of time a layer must take to print. If a layer will take less than this amount of time, the movement speed is reduced so the layer print time will match this value, down to the [[ | + | |The minimum amount of time a layer must take to print. If a layer will take less than this amount of time, the movement speed is reduced so the layer print time will match this value, down to the [[Settings/Filament/Cooling/Cooling_Thresholds/Minimum Print Speed|minimum print speed]] at the slowest.|*seconds| |
=== seconds === | === seconds === | ||
In this example, if a layer will take less than 40 seconds to print, print speed will be slowed to attempt to have the layer take this long to print.}} | In this example, if a layer will take less than 40 seconds to print, print speed will be slowed to attempt to have the layer take this long to print.}} | ||
Latest revision as of 18:18, 13 September 2018
|
|
Migrating: For MatterControl 2.0 the MatterControl documentation is moving to matterhackers.com/mattercontrol/support/. |
Function
The minimum amount of time a layer must take to print. If a layer will take less than this amount of time, the movement speed is reduced so the layer print time will match this value, down to the minimum print speed at the slowest.
Parameters
- seconds
Example(s)
seconds
In this example, if a layer will take less than 40 seconds to print, print speed will be slowed to attempt to have the layer take this long to print.
