Difference between revisions of "SETTINGS/Filament/Extrusion/Flow/Extrusion Multiplier"

From MatterControl Manual
< SETTINGS‎ | Filament‎ | Extrusion‎ | Flow
Jump to: navigation, search
 
(4 intermediate revisions by one other user not shown)
Line 1: Line 1:
 +
{{Migrated|slice-settings/filament/advanced#extrusion-multiplier}}
 
{{Slice Settings
 
{{Slice Settings
  

Latest revision as of 18:20, 5 April 2019

Merge

Migrating: For MatterControl 2.0 the MatterControl documentation is moving to matterhackers.com/mattercontrol/support/.
This page is in the process of being migrated. It's new home will be matterhackers.com/mattercontrol/support/slice-settings/filament/advanced#extrusion-multiplier.

A screenshot of the Extrusion Multiplier setting as seen in MatterControl's SETTINGS pane.

Function

A multiplier for modifying the extrusion flow rate.

This value can also be adjusted during a print using the Extrusion Multiplier slider on the Controls pane. Keep in mind using the function in Controls will have an effect in addition to any existing multiplier used in the setting described on this page. For example, if the slicer setting is set at 1.06 and then the slider in Controls is used during the print and set to 1.08, the total result will be a multiplier of 1.1448 (1.06 * 1.08).

Formula

The general extrusion flow formula: layer height / (filament area (pi*r²) * extrusion multiplier)

Parameters

  • multiplier

Range

Increasing it above 1 (1.1 is a good max value) will increase the amount of filament being extruded; decreasing it (.9 is a good minimum value) will decrease the amount being extruded.

Example(s)

multiplier

In this example, all extrusions will be multiplied by 1.04.

Extrusion Multiplier-ss-ex.png