Difference between revisions of "SETTINGS/Filament/Material/Properties/Diameter"
From MatterControl Manual
< SETTINGS | Filament | Material | Properties
(Created page with "{{Slice Settings |The actual diameter of the filament used for printing. Measure 5 times with calipers, throw out the top and bottom, and average the remaining 3.|*millimeter...") |
(No difference)
|
Revision as of 16:49, 23 December 2015
Function
The actual diameter of the filament used for printing. Measure 5 times with calipers, throw out the top and bottom, and average the remaining 3.
Parameters
- millimeters (mm)
Example(s)
mm
In this example, the filament diameter is 1.75 mm.
