Difference between revisions of "SETTINGS/Filament/Retraction/While Printing/Extra Length On Restart"

Latest revision as of 18:50, 8 April 2019

Migrating: For MatterControl 2.0 the MatterControl documentation is moving to matterhackers.com/mattercontrol/support/.
This page is in the process of being migrated. It's new home will be matterhackers.com/mattercontrol/support/slice-settings/filament/retraction#extra-length-on-restart.

A screenshot of the Extra Length On Restart setting as seen in MatterControl's SETTINGS pane.

Maximum length of filament to extrude after a complete retraction (in addition to the re-extrusion of the Length on Move distance).

Limited by the Time For Extra Length setting.

Can be zero.

Can be negative.

In this example, an additional 0.5 mm will be extruded after retraction.

@@ Line 1: / Line 1: @@
+{{Migrated|slice-settings/filament/retraction#extra-length-on-restart}}
 {{Slice Settings
-|Length of filament to extrude after a complete retraction (in addition to the re-extrusion of the [[Settings/Filament/Filament/Retraction/Length on Move|Length on Move]] distance).|*millimeters (mm)
+|Maximum length of filament to extrude after a complete retraction (in addition to the re-extrusion of the [[Settings/Filament/Retraction/While Printing/Length on Move|Length on Move]] distance).
+Limited by the [[SETTINGS/Filament/Retraction/While_Printing/Time_For_Extra_Length|Time For Extra Length]] setting.|*millimeters (mm)
 Can be zero.
@@ Line 9: / Line 12: @@
 === mm ===
-In this example, an additional 0.1 mm will be extruded after retraction.}}
+In this example, an additional 0.5 mm will be extruded after retraction.}}