Time For Extra Length
< SETTINGS | Filament | Retraction | While PrintingRevision as of 14:25, 1 August 2017 by MatterHackers (Talk | contribs)
Revision as of 14:25, 1 August 2017 by MatterHackers (Talk | contribs)
Function
The length of time, over which the Extra Length On Restart will be increased proportionally to its maximum value. Below this specified time only a portion of the extra length will be applied.
Set to 0 to apply the entire amount all the time.
Parameters
- seconds (s)
Can be zero.
Example(s)
This example shows a length of two seconds for the amount of time designated to fulfill Extra Length On Restart. If the move takes less than this amount of time, the Extra Length On Restart will be applied proportionally.
