Difference between revisions of "SETTINGS/General/Infill/Advanced/Infill Overlap"
From MatterControl Manual
| Line 1: | Line 1: | ||
{{Slice Settings | {{Slice Settings | ||
| − | |The amount the infill edge will push into the perimeter. Helps ensure the infill is connected to the edge.| | + | |The amount the infill edge will push into the perimeter. Helps ensure the infill is connected to the edge.|*millimeters (mm) |
Can be zero.| | Can be zero.| | ||
Revision as of 18:18, 18 December 2015
Function
The amount the infill edge will push into the perimeter. Helps ensure the infill is connected to the edge.
Parameters
- millimeters (mm)
Can be zero.
Example(s)
mm
On the right half of this screenshot, the three lines on the left are the perimeters, and the diagonal lines on the right are the infill. The infill overlaps just 0.06 mm, which is usually enough to ensure that the infill will stick to the inside-most perimeter.
