Starting Angle

< SETTINGS‎ | General‎ | Infill‎ | Advanced

Revision as of 13:55, 20 January 2016 by MatterHackers (Talk | contribs) (MatterHackers moved page Slice Settings/General/Infill/Advanced/Starting Angle to Settings/General/Infill/Advanced/Starting Angle without leaving a redirect)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Revision as of 13:55, 20 January 2016 by MatterHackers (Talk | contribs) (MatterHackers moved page Slice Settings/General/Infill/Advanced/Starting Angle to Settings/General/Infill/Advanced/Starting Angle without leaving a redirect)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

A screenshot of the Starting Angle setting as seen in MatterControl's SETTINGS pane.

Function

The angle of the infill, measured from the X axis. Not used when bridging.

Parameters

degrees

Can be zero.

Example(s)

degrees

This infill is tilted 35 degrees from the X axis.

Starting Angle-ss-ex.png

Last modified on 12 September 2018, at 11:54