Difference between revisions of "SETTINGS/General/Layers-Surface/Layer Height/First Layer Height"
From MatterControl Manual
< SETTINGS | General | Layers-Surface | Layer Height
| (4 intermediate revisions by one other user not shown) | |||
| Line 1: | Line 1: | ||
| + | {{Migrated|slice-settings/general/general#first-layer-thickness}} | ||
{{Slice Settings | {{Slice Settings | ||
|The height of the first layer. A first layer taller than the default layer height can ensure good adhesion to the build plate.|*millimeters (mm) | |The height of the first layer. A first layer taller than the default layer height can ensure good adhesion to the build plate.|*millimeters (mm) | ||
| − | *percent (%)| | + | *percent [of [[Settings/General/Layers-Surface/Layer Height/Layer Height|Layer Height]]] (%)| |
=== mm === | === mm === | ||
| Line 10: | Line 11: | ||
=== % === | === % === | ||
| − | Must enter '%' after input to activate. Used to specify height of first layer relative to [[ | + | Must enter '%' after input to activate. Used to specify height of first layer relative to [[Settings/General/Layers-Surface/Layer Height/Layer Height|Layer Height]] as a percentage. |
[[File:{{SUBPAGENAME}}-ss-ex1.png]] | [[File:{{SUBPAGENAME}}-ss-ex1.png]] | ||
Latest revision as of 11:07, 5 September 2018
|
|
Migrating: For MatterControl 2.0 the MatterControl documentation is moving to matterhackers.com/mattercontrol/support/. |
Function
The height of the first layer. A first layer taller than the default layer height can ensure good adhesion to the build plate.
Parameters
- millimeters (mm)
- percent [of Layer Height] (%)
Example(s)
mm
Used as the default if no parameter type is specified. Will create a first layer of the specified millimeters thick.
%
Must enter '%' after input to activate. Used to specify height of first layer relative to Layer Height as a percentage.
