Difference between revisions of "SETTINGS/General/Layers-Surface/Outer Surface - Perimeters"
From MatterControl Manual
< SETTINGS | General | Layers-Surface
(Created page with "Category:Incomplete") |
|||
| Line 1: | Line 1: | ||
| − | [[Category: | + | __NOTOC__{{DISPLAYTITLE:{{SUBPAGENAME}}}}[[File:{{SUBPAGENAME}}-subsection.png|right|framed|<center>The '{{SUBPAGENAME}}' sub-section as shown in the MatterControl Settings pane.</center>]] |
| + | {{SUBPAGENAME}} is a sub-section of the [[Slice Settings/General/Layers-Surface|Layers/Surface]] section of the {{#titleparts: {{PAGENAME}} | -2 | -3 }} slice settings category which deal with the outer shell of the print. | ||
| + | |||
| + | [[Category:Slice Settings]] | ||
Revision as of 12:09, 18 December 2015
Outer Surface - Perimeters is a sub-section of the Layers/Surface section of the General slice settings category which deal with the outer shell of the print.
