Difference between revisions of "SETTINGS/General/Layers-Surface/Outer Surface - Perimeters"
From MatterControl Manual
< SETTINGS | General | Layers-Surface
| Line 1: | Line 1: | ||
| − | __NOTOC__{{DISPLAYTITLE:{{SUBPAGENAME}}}} | + | __NOTOC__{{DISPLAYTITLE:{{SUBPAGENAME}}}} |
{{SUBPAGENAME}} is a sub-section of the [[Slice Settings/General/Layers-Surface|Layers/Surface]] section of the {{#titleparts: {{PAGENAME}} | -2 | -3 }} slice settings category which deals with the outer shell of the print. | {{SUBPAGENAME}} is a sub-section of the [[Slice Settings/General/Layers-Surface|Layers/Surface]] section of the {{#titleparts: {{PAGENAME}} | -2 | -3 }} slice settings category which deals with the outer shell of the print. | ||
| + | |||
| + | [[File:{{SUBPAGENAME}}-subsection.png|none|framed|<center>The '{{SUBPAGENAME}}' sub-section as shown in the MatterControl Settings pane.</center>]] | ||
[[Category:Slice Settings]] | [[Category:Slice Settings]] | ||
Revision as of 13:05, 18 December 2015
Outer Surface - Perimeters is a sub-section of the Layers/Surface section of the General slice settings category which deals with the outer shell of the print.
