Open main menu

Start End Overlap

< SETTINGS‎ | General‎ | Layers-Surface‎ | Outer Surface - Perimeters
Revision as of 18:21, 15 November 2016 by MatterHackers (Talk | contribs)

Revision as of 18:21, 15 November 2016 by MatterHackers (Talk | contribs)

A screenshot of the Start End Overlap setting as seen in MatterControl's SETTINGS pane.

Function

The distance that a perimeter will overlap itself when it completes its loop, expressed as a percentage of the Nozzle Diameter.

Parameters

  • percent

Example(s)

percent

This diagram illustrates how Start End Overlap works:

Start End Overlap-ss-ex.png
Last modified on 6 September 2018, at 16:19