Difference between revisions of "SETTINGS/General/Raft-Priming/Raft/Fan Speed"
From MatterControl Manual
< SETTINGS | General | Raft-Priming | Raft
m (MatterHackers moved page Settings/General/Raft-Priming/Raft/Fan Speed to SETTINGS/General/Raft-Priming/Raft/Fan Speed) |
|||
| Line 1: | Line 1: | ||
{{Slice Settings | {{Slice Settings | ||
| − | |The speed at which the cooling fan(s) will run during the printing of the raft, expressed as a percentage of full power.|*percent (%) | + | |The speed at which the cooling fan(s) will run during the printing of the raft, expressed as a percentage of full power. |
| + | |||
| + | === Restrictions === | ||
| + | |||
| + | *Not shown if [[SETTINGS/Printer/Features/Hardware/Has Fan|Has Fan]] is disabled.|*percent (%) | ||
While the value can be any whole number from 0-100, the following values will produce these effects: | While the value can be any whole number from 0-100, the following values will produce these effects: | ||
Latest revision as of 18:39, 6 December 2016
Function
The speed at which the cooling fan(s) will run during the printing of the raft, expressed as a percentage of full power.
Restrictions
- Not shown if Has Fan is disabled.
Parameters
- percent (%)
While the value can be any whole number from 0-100, the following values will produce these effects:
0% : off
50% : half speed
100% : full speed
Example(s)
%
At 100% the cooling fan(s) will be on at full blast during the printing of the raft.
