Difference between revisions of "SETTINGS/General/Single Print/Settings Will Clear at End of Print/Bottom Clip"
< SETTINGS | General | Single Print | Settings Will Clear at End of Printm (MatterHackers moved page Settings/General/Single Print/Settings Will Clear at End of Print/Bottom Clip to SETTINGS/General/Single Print/Settings Will Clear at End of Print/Bottom Clip) |
|
(2 intermediate revisions by the same user not shown) | |
(No difference)
|
Latest revision as of 13:37, 1 December 2016
Function
The amount to remove from the bottom of the model, in millimeters.
Useful for printing portions of a larger print that failed at a certain height so the two pieces can be glued together.
Essentially, this function adjusts the position of the model to be X millimeters below the print bed, then slices everything above. Negative numbers can be used to move the model up instead of down.
Parameters
- millimeters (mm)
Can be zero.
Can be negative.