Difference between revisions of "SETTINGS/General/Single Print/Settings Will Clear at End of Print/Bottom Clip"
< SETTINGS | General | Single Print | Settings Will Clear at End of Printm (MatterHackers moved page Slice Settings/General/Layers-Surface/Layer Height/Bottom Clip to Settings/General/Layers-Surface/Layer Height/Bottom Clip without leaving a redirect) |
m (MatterHackers moved page Settings/General/Single Print/Settings Will Clear at End of Print/Bottom Clip to SETTINGS/General/Single Print/Settings Will Clear at End of Print/Bottom Clip) |
(One intermediate revision by the same user not shown) | |
(No difference)
|
Latest revision as of 13:37, 1 December 2016
Function
The amount to remove from the bottom of the model, in millimeters.
Useful for printing portions of a larger print that failed at a certain height so the two pieces can be glued together.
Essentially, this function adjusts the position of the model to be X millimeters below the print bed, then slices everything above. Negative numbers can be used to move the model up instead of down.
Parameters
- millimeters (mm)
Can be zero.
Can be negative.