Bottom Clip
< SETTINGS | General | Single Print | Settings Will Clear at End of PrintRevision as of 13:55, 20 January 2016 by MatterHackers (Talk | contribs) (MatterHackers moved page Slice Settings/General/Layers-Surface/Layer Height/Bottom Clip to Settings/General/Layers-Surface/Layer Height/Bottom Clip without leaving a redirect)
Revision as of 13:55, 20 January 2016 by MatterHackers (Talk | contribs) (MatterHackers moved page Slice Settings/General/Layers-Surface/Layer Height/Bottom Clip to Settings/General/Layers-Surface/Layer Height/Bottom Clip without leaving a redirect)
Function
The amount to remove from the bottom of the model, in millimeters.
Useful for printing portions of a larger print that failed at a certain height so the two pieces can be glued together.
Essentially, this function adjusts the position of the model to be X millimeters below the print bed, then slices everything above. Negative numbers can be used to move the model up instead of down.
Parameters
- millimeters (mm)
Can be zero.
Can be negative.