Layer(s) To Pause
< SETTINGS | General | Single Print | Settings Will Clear at End of PrintRevision as of 12:45, 13 September 2016 by MatterHackers (Talk | contribs)
Revision as of 12:45, 13 September 2016 by MatterHackers (Talk | contribs)
Function
The layers at which the print will pause, allowing for a change in filament.
Parameters
- layer number
Leave blank to disable. If you would like to pause on multiple layers, separate the layer numbers with semicolons. For example: "15; 37".
Does not work when printing from SD card; the printer must be connected via active serial connection to function properly.