Layer(s) To Pause

< SETTINGS‎ | General‎ | Single Print‎ | Settings Will Clear at End of Print
Revision as of 11:03, 14 August 2017 by MatterHackers (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Revision as of 11:03, 14 August 2017 by MatterHackers (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
A screenshot of the Layer(s) To Pause setting as seen in MatterControl's SETTINGS pane.

Function

The layer(s), at the beginning of which the print will pause, allowing for a change in filament.

Parameters

  • layer number

Leave blank to disable. If you would like to pause on multiple layers, separate the layer numbers with semicolons. For example: "15; 37".

Does not work when printing from SD card; the printer must be controlling the printer via active serial connection to function properly.

Example(s)

layer number

In this example, the print will pause at the 5th layer to allow the user to change filament.

Layer(s) To Pause-ss-ex.png