Difference between revisions of "SETTINGS/General/Speed/Speed for Perimeters/Outside Perimeter"
From MatterControl Manual
< SETTINGS | General | Speed | Speed for Perimeters
| Line 2: | Line 2: | ||
|The speed at which outside, external, or the otherwise visible perimeters will print.|*millimeters per second (mm/s) | |The speed at which outside, external, or the otherwise visible perimeters will print.|*millimeters per second (mm/s) | ||
| − | * | + | *percent [of [[Slice_Settings/General/Speed/Speed_for_Perimeters/Inside_Perimeters|inside perimeters]]] (%).| |
=== mm/s === | === mm/s === | ||
Revision as of 17:54, 21 December 2015
Function
The speed at which outside, external, or the otherwise visible perimeters will print.
Parameters
- millimeters per second (mm/s)
- percent [of inside perimeters] (%).
Example(s)
mm/s
In this example, the outside perimeters will print at 25 mm/s.
%
In this example, the outside perimeters will print at 60% of the Inside Perimeters speed (which if you can make out the blurred text is set at 40), so the final result will be 24 mm/s.
