Difference between revisions of "SETTINGS/General/Support Material/Support Material/Generate Support Material"
From MatterControl Manual
< SETTINGS | General | Support Material | Support Material
m (MatterHackers moved page Slice Settings/General/Support Material/Support Material/Generate Support Material to Settings/General/Support Material/Support Material/Generate Support Material without leaving a redirect) |
|
(No difference)
| |
Revision as of 13:37, 1 December 2016
Function
Generates support material under areas of the part which may be too steep to support themselves.
Parameters
- Boolean
Example(s)
Boolean
The check box is checked to use the function.
The check box is unchecked to leave the function unused.
