Changes

Created page with "{{Slice Settings |The percentage of extrusion width that overlaps on the previous layer which will trigger support material generation. This replaces the Settings/General/..."
{{Slice Settings

|The percentage of extrusion width that overlaps on the previous layer which will trigger support material generation.

This replaces the [[Settings/General/Support Material/Support Material/Amount|Amount]] setting which was deprecated in version 1.5.|*percent (%)

=== Presets ===

*Little : 10%
*Standard : 50%
*Lots : 90%
*Custom : user-defined|

=== percent ===

In this example, a layer with an extrusion width which hangs 50% off over the previous layer will have support material generated.}}

[[File:{{SUBPAGENAME}}-ss-ex1.png]]