Difference between revisions of "SETTINGS/General/Support Material/Support Options/Support Percent"
m (MatterHackers moved page Settings/General/Support Material/Support Options/Support Percent to SETTINGS/General/Support Material/Support Options/Support Percent)
|Line 1:||Line 1:|
Latest revision as of 18:16, 25 September 2018
Migrating: For MatterControl 2.0 the MatterControl documentation is moving to matterhackers.com/mattercontrol/support/.
The percentage of extrusion width that overlaps on the previous layer which will trigger support material generation.
This replaces the Amount setting which was deprecated starting in version 1.5.
- percent (%)
- Little : 10%
- Standard : 50%
- Lots : 90%
- Custom : user-defined
In this example, a layer with an extrusion width which hangs 50% off over the previous layer will have support material generated.