Difference between revisions of "SETTINGS/General/Support Material/Support Options/Support Percent"
From MatterControl Manual
< SETTINGS | General | Support Material | Support Options
(Created page with "{{Slice Settings |The percentage of extrusion width that overlaps on the previous layer which will trigger support material generation. This replaces the Settings/General/...") |
|||
| Line 3: | Line 3: | ||
|The percentage of extrusion width that overlaps on the previous layer which will trigger support material generation. | |The percentage of extrusion width that overlaps on the previous layer which will trigger support material generation. | ||
| − | This replaces the [[Settings/General/Support Material/Support Material/Amount|Amount]] setting which was deprecated in version 1.5.|*percent (%) | + | This replaces the [[Settings/General/Support Material/Support Material/Amount|Amount]] setting which was deprecated starting in version 1.5.|*percent (%) |
=== Presets === | === Presets === | ||
Revision as of 14:25, 1 August 2016
Function
The percentage of extrusion width that overlaps on the previous layer which will trigger support material generation.
This replaces the Amount setting which was deprecated starting in version 1.5.
Parameters
- percent (%)
Presets
- Little : 10%
- Standard : 50%
- Lots : 90%
- Custom : user-defined
Example(s)
percent
In this example, a layer with an extrusion width which hangs 50% off over the previous layer will have support material generated.
