Difference between revisions of "SETTINGS/Printer/Custom G-Code/On Connect G-Code"
From MatterControl Manual
< SETTINGS | Printer | Custom G-Code
m (MatterHackers moved page Settings/Printer/Custom G-Code/On Connect G-Code to SETTINGS/Printer/Custom G-Code/On Connect G-Code) |
|||
| Line 1: | Line 1: | ||
{{Slice Settings | {{Slice Settings | ||
| − | |G-Code to run upon successful connection to a printer. This can be useful to set settings specific to a given printer. | + | |G-Code to run upon successful connection to a printer. This can be useful to set settings specific to a given printer. For instance, for S3G printers it is used to tell the printer the steps per mm for each axis and the homing offset. |
'''NOTE:''' All Custom G-Code is subject to [[G-Code Filtering|filtering rules]].|*G-Code | '''NOTE:''' All Custom G-Code is subject to [[G-Code Filtering|filtering rules]].|*G-Code | ||
Revision as of 12:07, 6 December 2016
Function
G-Code to run upon successful connection to a printer. This can be useful to set settings specific to a given printer. For instance, for S3G printers it is used to tell the printer the steps per mm for each axis and the homing offset.
NOTE: All Custom G-Code is subject to filtering rules.
Parameters
- G-Code
- Custom G-Code variables
All G-Code must be uppercase to function properly.
Example(s)
G-Code
In this example, the printer will home (G28) when MatterControl makes a successful connection.
