2,552
edits
Changes
m
Will accept '''NOTE:''' All Custom G-Code is subject to [[G-Code Filtering|filtering rules]].|*G-Code*[[Custom_G-Code_Variables|Custom G-Code variables]] All G-Code must be uppercase to function properly.|
MatterHackers moved page Settings/Printer/Custom G-Code/Pause G-Code to SETTINGS/Printer/Custom G-Code/Pause G-Code
{{Slice Settings
|G-Code to run when the printer is [[Pause button|paused]].|*G-Code
=== G-Code ===
In this example, when the 'Pause' button is pressed during a print, the printer will set coordinates relative to the current position (G91), then move 10 mm up and retract 10 mm of filament at a rate of 12,000 mm/minute (G1 Z10 E-10 F12000), then set coordinates to absolute positioning again (G90).}}
