Difference between revisions of "SETTINGS/Printer/Custom G-Code/Resume G-Code"

From MatterControl Manual
Jump to: navigation, search
(Created page with "{{Slice Settings |G-Code to be run when the print resumes after a pause.|*G-Code Will accept Custom G-Code variables.| === G-C...")
 
Line 7: Line 7:
 
=== G-Code ===
 
=== G-Code ===
  
In this example, the printer will set coordinates relative to the current position (G91), then move 10 mm down and extrude 10.8 mm of filament at a rate of 12,000 mm/minute (G1 Z10 E-10 F12000), then set coordinates to absolute positioning again (G90).}}
+
In this example, when the 'Resume' button is pressed, the printer will set coordinates relative to the current position (G91), then move 10 mm down and extrude 10.8 mm of filament at a rate of 12,000 mm/minute (G1 Z10 E-10 F12000), then set coordinates to absolute positioning again (G90).}}

Revision as of 14:54, 13 January 2016

A screenshot of the Resume G-Code setting as seen in MatterControl's SETTINGS pane.

Function

G-Code to be run when the print resumes after a pause.

Parameters

  • G-Code

Will accept Custom G-Code variables.

Example(s)

G-Code

In this example, when the 'Resume' button is pressed, the printer will set coordinates relative to the current position (G91), then move 10 mm down and extrude 10.8 mm of filament at a rate of 12,000 mm/minute (G1 Z10 E-10 F12000), then set coordinates to absolute positioning again (G90).

Resume G-Code-ss-ex.png