2,552
edits
Changes
m
Will accept '''NOTE:''' All Custom G-Code is subject to [[G-Code Filtering|filtering rules]].|*G-Code*[[Custom_G-Code_Variables|Custom G-Code variables]] All G-Code must be uppercase to function properly.|
MatterHackers moved page Settings/Printer/Custom G-Code/Resume G-Code to SETTINGS/Printer/Custom G-Code/Resume G-Code
{{Slice Settings
|G-Code to be run when the print [[Resume button|resumes]] after a pause.|*G-Code
=== G-Code ===
In this example, when the 'Resume' button is pressed after the print has been paused, the printer will set coordinates relative to the current position (G91), then move 10 mm down and extrude 10.8 mm of filament at a rate of 12,000 mm/minute (G1 Z-10 E10.8 F12000), then set coordinates to absolute positioning again (G90).}}
