Leveling Solution

< SETTINGS‎ | Printer‎ | Print Leveling‎ | Machine Settings
Revision as of 18:25, 6 December 2016 by MatterHackers (Talk | contribs)

Revision as of 18:25, 6 December 2016 by MatterHackers (Talk | contribs)

A screenshot of the Leveling Solution setting as seen in MatterControl's SETTINGS pane.

Function

The print leveling algorithm to use when the Software Print Leveling wizard runs.

Note: This section (Print Recovery) is not shown when Has Hardware Leveling is enabled as only one form of leveling can be used at a time.

Parameters

Available as presets only:

  • 3-Point Plane
  • 7-Point Disk
  • 13-Point Disk

Example(s)

3-Point Plane

In this example, the printer will use the 3-Point Plane algorithm during the Software Print Leveling wizard.

Leveling Solution-ss-ex.png

7-Point Disk

In this example, the printer will use the 7-Point Disk algorithm during the Software Print Leveling wizard.

Leveling Solution-ss-ex1.png

13-Point Disk

In this example, the printer will use the 13-Point Disk algorithm during the Software Print Leveling wizard.

Leveling Solution-ss-ex2.png