Difference between revisions of "SETTINGS/Printer/Print Leveling/Probe Settings/Z Offset"
From MatterControl Manual
< SETTINGS | Printer | Print Leveling | Probe Settings
| Line 1: | Line 1: | ||
{{Slice Settings | {{Slice Settings | ||
| − | |The thickness of the paper (or other calibration device) used to perform manual bed probe.|*millimeters (mm)| | + | |The thickness of the paper (or other calibration device) used to perform manual bed probe. |
| + | |||
| + | === Restrictions === | ||
| + | |||
| + | *This section (Print Recovery) is not shown when [[SETTINGS/Printer/Features/Hardware/Has Hardware Leveling|Has Hardware Leveling]] is enabled as only one form of leveling can be used at a time.|*millimeters (mm)| | ||
=== mm === | === mm === | ||
In this example, the paper to be used during the manual bed probe is 0.1 mm thick.}} | In this example, the paper to be used during the manual bed probe is 0.1 mm thick.}} | ||
Revision as of 18:27, 6 December 2016
Function
The thickness of the paper (or other calibration device) used to perform manual bed probe.
Restrictions
- This section (Print Recovery) is not shown when Has Hardware Leveling is enabled as only one form of leveling can be used at a time.
Parameters
- millimeters (mm)
Example(s)
mm
In this example, the paper to be used during the manual bed probe is 0.1 mm thick.
