Difference between revisions of "SETTINGS/Printer/Print Recovery/Recover Settings/Recover Layer Speed"
From MatterControl Manual
< SETTINGS | Printer | Print Recovery | Recover Settings
(Created page with "{{Slice Settings |Function text|*parameters text| === Parameter 1 === Caption for Example for Parameter 1.}} === Parameter 2 === Caption for example for Parameter 2. F...") |
|||
| (3 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
{{Slice Settings | {{Slice Settings | ||
| − | | | + | |The speed at which the nozzle will move when recovering a failed print, for one layer. |
| − | === | + | === Restrictions === |
| − | + | *This section (Print Recovery) is not shown when [[SETTINGS/Printer/Features/Hardware/Has Hardware Leveling|Has Hardware Leveling]] is enabled as G29 procedures could interfere with a partially-completed print.|*millimeters per second (mm/s)| | |
| − | === | + | === mm/s === |
| − | + | In this example the nozzle will move at 10 mm/s whilst printing the layer the printer was on when it failed.}} | |
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
Latest revision as of 18:32, 6 December 2016
Function
The speed at which the nozzle will move when recovering a failed print, for one layer.
Restrictions
- This section (Print Recovery) is not shown when Has Hardware Leveling is enabled as G29 procedures could interfere with a partially-completed print.
Parameters
- millimeters per second (mm/s)
Example(s)
mm/s
In this example the nozzle will move at 10 mm/s whilst printing the layer the printer was on when it failed.
