Recover Layer Speed
< SETTINGS | Printer | Print Recovery | Recover SettingsRevision as of 18:21, 6 December 2016 by MatterHackers (Talk | contribs)
Revision as of 18:21, 6 December 2016 by MatterHackers (Talk | contribs)
Function
The speed at which the nozzle will move when recovering a failed print, for one layer.
Note: Not shown when Has Hardware Leveling is enabled as G29 procedures could interfere with a partially-completed print.
Parameters
- millimeters per second (mm/s)
Example(s)
mm/s
In this example the nozzle will move at 10 mm/s whilst printing the layer the printer was on when it failed.
